适用于 Windows 10 的 Apple Magic Keyboard A1644 驱动程序
Apple Magic Keyboard A1644 driver for Windows 10.
Please note that this driver only works on Windows 10 and only for the A1644 (Apple Magic Keyboard) model (see: FAQ.5).
Features:
WinAppleKey is implemented as a HIDCLASS LowerFilter WDM kernel mode driver.
DISCLAIMER: This driver is signed with a self-signed (test/development) certificate. For that reason, Windows will not allow the driver installation unless running in TESTSIGNING mode. Please be aware that permanently running Windows in TESTSIGNING mode leaves your system open to potential security risks. Any consequence because of this is solely your own responsibility. WinAppleKey is free software that you are willing to build and/or use completely at your own risk. If your system is running a UEFI BIOS with Secure Boot enabled, you will need to disable Secure Boot in BIOS first before enabling TESTSIGNING mode.
To switch to TESTSIGNING mode issue the following command (in an Administrative command prompt) and then reboot your PC:
bcdedit.exe -set TESTSIGNING ON
You can now run the Setup.msi installer.
To uninstall, run the uninstaller from the Control Panel Programs and then manually revert TESTSIGNING mode by issuing the following command (in an Administrative command prompt):
bcdedit.exe -set TESTSIGNING OFF
WinAppleKey creates the following key mappings:
Input Key(s)
Output Key
LCtrlFn
FnLeft Ctrl
⏏︎ EjectDel
⌘ CmdAlt
⌥ AltCmd
Fn+[F1]...[F12][F13]...[F24]
Fn+LCtrlRight Ctrl
Fn+ReturnInsert
Fn+PPrint Screen
Fn+SScroll Lock
Fn+BPause/Break
Fn+↑Page Up
Fn+↓Page Down
Fn+←Home
Fn+→EndMultimedia Keys: The multimedia keys are not directly mapped as they correspond to F19-F24 instead but you can easily use this AutoHotkey script for that purpose. Please note that this currently works only over the wired connection.
You can use regedit.exe to optionally modify certain driver settings.
To enable/disable the Alt-Cmd key swapping edit the DWORD key value: HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Services\WinAppleKey\SwapAltCmd. The default value is 0 (off).
To enable/disable the Fn-Ctrl key swapping edit the DWORD key value: HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Services\WinAppleKey\SwapFnCtrl. The default value is 1 (on).
After changing any of these values, you will need to disconnect/connect your associated Apple keyboard(s) to trigger a driver reload, or alternatively reboot your machine.
To build the driver you will need Visual Studio 2019 along with an installation of the Windows 10 Driver Kit (WDK). For the installer project, you will additionally need to install the WiX toolset.
Unfortunately, I can't. This is due to Microsoft's enforced restrictions for Windows drivers. To fully release a device driver for Windows 10 (and later) you need to run a registered company and subsequently purchase a quite expensive driver signing certificate for that company. Both cost time and money. This driver is free and open source and I do not make any money from it - so no.
Please take a look at paragraph Multimedia Keys above.
This is an issue of the Apple keyboard hardware rather than the driver. You can use the ctrl-rshift-t combination instead.
The value is protected by Secure Boot policy and cannot be modified or deleted.You must disable Windows Secure Boot, please read the Disclaimer part.
暂无开放 Issues,或尚未同步最近议题。