Baike.dev
All toolsOnline toolsAI codingTrendingOpen sourceNewsSubmit
Log in
< Back to tools
B

bldc-drive

> 编程语言
Open source

Cheap and simple brushless DC motor driver designed for CNC applications using STM32 microcontroller

199 stars0 likes0 views
WebsiteGitHub

About

Cheap and simple brushless DC motor driver designed for CNC applications using STM32 microcontroller

bldc-drive

This is a project developing a simple BLDC servo controller. It is based on an STM32F103 microcontroller.

Some parts, especially the PID control loop is based on development done by user mcm_xyz in cnczone.com forum. Thank you! Check the thread http://www.cnczone.com/forums/open-source-controller-boards/283428-cnc.html

Disclaimer

This software and hardware is provided "AS IS", WITHOUT ANY WARRANTY. The software is released under GPL v2. Authors accept no liability for any harm or loss resulting from use of this hardware or software.

Authors & Contributors

  • original Software by mcm_xyz from cnczone
  • first Version of Hardware&Software in a Git-repo from pekkaroi via https://github.com/pekkaroi
  • Schematic-additions and fork by Philipp Hörauf via https://github.com/Virtex7

Firmware

Firmware is a work-in-progress (and will be for a while :), however following features are included:

  • Trapezoidal BLDC commutation using either HALL sensors or quadrature encoder.
  • Step+Dir input interface with PID position control loop.
  • PWM+Dir input interface in velocity mode.
  • USART communitacation for configuration. Configuration settings saved to flash memory.
  • TODO: Motor Test Mode to simply activate a Motor with a fixed frequency, no encoder needed

Update 1st May 2016

Some updates to the firmware.

  • ADC current limiting implemented. Appears to work OK
  • I created a quick and ugly Python gui for tuning
  • Updated the PID loop to have feedfoward coefficients FF1 and FF2 (like LinuxCNC). This means that the PID output can be adjusted by the requested speed and the requested acceleration. This made the PID tuning a lot easier for me at least, I'm able to get a motor to follow the requested position very well also during acceleration and during constant drive.

Hardware:

First prototype hardware is built and it is working well. However, there are couple of known issues:

  • 6n137 optocoupler is not officially supporting 3.3V supply voltage which is used in the board. In reality they seem to work, but the optocoupler should be changed or additional levelshifting circuitry added on next revision. Also, the optocoupler input circuit supports only push-pull-type encoder output. Many encoders seem to have open drain output. :(
  • Few connectors in the layout missed solder stop openings. They were bit painfull to solder. :)
  • The current amplifier INA27x connection is wrong. The IN+ and IN- should be swapped.

STATUS QUO:

Second hardware revision with the above findings fixed is published. There are no known issues, two servo drives are succesfully driving my CNC router. Pics and videos to come..

HARDWARE TODOs:

  • verify all part-values into the schematic

Issues· 0 open

View all issuesOpen on GitHub

No open issues yet, or sync has not completed.

> Tags

C

No comments yet. Be the first to share.

> Details

PublishedAug 1, 2026
UpdatedSep 18, 2026
Category编程语言
PricingOpen source

> Related tools

T
TypeScript
JavaScript 的超集,为前端与全栈提供静态类型
P
Python
通用编程语言,广泛用于 Web、数据与 AI
G
Go
Google 推出的简洁高效系统语言