[RC Feedback] Feedback on the 2.0.0rc5 Release Candidate

Feedback

Please provide general feedback on your experience with the 2.0.0rc5 Release Candidate here. An "All is working fine" is valuable feedback as well, because it tells me that people in fact are testing the RC and just not finding any problems. If you run into any bugs however, please open a full bug report and link it here! Thanks :)

Things to take a closer look at

For this RC, these things should get a closer look while testing, if possible:

1. proper behaviour when using the included web interface as well as any third party clients at your disposal
2. printing via a serial connection
3. managing files on your printer's storage via a serial connection
4. blocklisted serial ports and/or baud rates are properly migrated to the serial connector (one per line, not comma-separated)
5. if your printer's disconnected state happens to be "after error", please report back on which connector you used and what the reported error is
6. if you have a Klipper/Moonraker based printer available: can you use it through OctoPrint when you install the Moonraker Connector?
7. if you have a Bambu based printer available: can you use it through OctoPrint when you install the Bambu Connector?

[!NOTE] As I'm still seeing a lot of so far unexplained "error" states, please take special note of item 5!

Update test matrix

Releases aren't rolled out unless all tests in the update test matrix succeed.

---

❗ IMPORTANT ❗

If you run into any obvious bugs not yet listed below, please open a new ticket and follow "How to file a bug report". I need full bug reports with system info bundles in the issue tracker, not just a statement somewhere that something doesn't work!

Please respect the process and don't make the already very stressful RC phase any more difficult for me!

❗ IMPORTANT ❗

---

Currently known issues

Unreproduced issues

Unreproduced and information for further analysis missing

• #5439
• #5443 - slop?
• #5444 - slop?

Third party issues

Issues needing analysis

Verification

• I'm a maintainer or collaborator of OctoPrint and allowed to use this issue type