● batear — Ultra-low-cost, off-grid acoustic drone detector. Edge computing. Protect your airspace with a microphone.
● batear — Ultra-low-cost, off-grid acoustic drone detector. Edge computing. Protect your airspace with a microphone.
Batear is officially fiscally hosted by the Open Source Collective (OSC). Your contribution directly supports the deployment of civil defense technology where it is needed most.
** Become a Sponsor on Open Collective**
Drones are an increasing threat to homes, farms, and communities — and effective detection has traditionally required expensive radar or camera systems. Batear changes that.
For ultra-low-cost hardware, Batear turns a tiny ESP32-S3 microcontroller and a MEMS microphone into an always-on acoustic drone detector. It runs entirely at the edge — no cloud subscription, no internet connection, no ongoing cost. Deploy one at a window, a fence line, or a rooftop and it will alert you the moment drone rotor harmonics are detected nearby.
The same codebase builds as a Detector (mic + LoRa TX), a Gateway (LoRa RX + OLED + LED + MQTT), or a Wired Detector (mic + Ethernet/PoE + MQTT), selectable at build time. The gateway forwards alerts to Home Assistant via MQTT with automatic device discovery; the wired detector publishes directly over Ethernet — no LoRa or gateway required, ideal for permanent installations.
Flash firmware directly from your browser — no toolchain needed:
Requires Chrome or Edge on desktop. Connect a Heltec V3/V4 (Detector or Gateway) or a LILYGO T-ETH-Lite S3 (Wired Detector) via USB-C and click Install.
Stop checking serial monitors. Batear brings drone detection directly to your dashboard.
"Batear bridges the gap between complex signal processing and simple home automation."
Full documentation is available at batear.io.
| Getting Started | Prerequisites and supported boards |
| Hardware | Parts list, wiring diagrams, pin map |
| Build & Flash | Compile and flash the firmware |
| Configuration | Encryption keys, frequencies, MQTT, device IDs |
| How It Works | FFT harmonic detection algorithm |
| Calibration | Tuning detection thresholds |
| Adding a Board | Porting to new hardware |
Batear supports two deployment models — pick whichever fits the site:
…┌──────────────────────┐
│ WIRED DETECTOR (×N) │ Ethernet (PoE)
│ │ ───────────────────────────► ┌──────────────────────┐
│ ICS-43434 mic │ MQTT / JSON │ HOME ASSISTANT │
│ FFT harmonic detect │ + REST API / OTA │ (auto-discovery) │
│ W5500 Ethernet │ └──────────────────────┘
└──────────────────────┘
LILYGO T-ETH-Lite S3# Clone
git clone https://github.com/batear-io/batear.git && cd batear
# Build detector (swap sdkconfig.detector → sdkconfig.gateway or
# sdkconfig.wired_detector for the other roles)
idf.py -B build_detector \
-DSDKCONFIG=build_detector/sdkconfig \
-DSDKCONFIG_DEFAULTS="sdkconfig.defaults;sdkconfig.detector" \
set-target esp32s3
idf.py -B build_detector -DSDKCONFIG=build_detector/sdkconfig build
# Flash (replace PORT)
idf.py -B build_detector -DSDKCONFIG=build_detector/sdkconfig -p PORT flash monitorSee the full build guide for gateway and wired-detector setup and detailed instructions.
Batear is a community-driven project. We welcome contributions, whether through code, field data, or financial sponsorship.
No open issues yet, or sync has not completed.